Do you want to make a custom woodworking tool? With the UJK Parf Mk II drilling system, you can make a professional, highly practical table configuration in less than 30 minutes. At first glance, the system seems complicated; but in reality, it is quite simple with very accurate results that are easy to achieve.

With the UJK Parf Mk II system, you will accurately drill holes with a diameter of 20 mm in the panel. The ratio between the holes is so precise that with the help of holes, inserts and tools at the table, you will easily and very precisely realize all woodworking operations; 90° cuts, 45° cuts at an angle,…

We first drill 3mm holes in the board using guides and a Parf Mk II bushing, then widen these holes with a bushing and a 20mm drill bit. This creates a network of holes into which inserts (dogs) and supports are inserted.

The UJK Parf MK II provides a precise grid of holes with 32mm or 46mm spacing, giving you plenty of options when cutting, assembling or clamping.

The Parf Mk II system contains two bars together with a drill guide and a special 3mm drill bit to create rows and columns of holes at perfect right angles. The accuracy of the system also depends on the very close tolerance of the holes in the Parf guides.

The system is designed in such a way that wear is not possible. Careful handling is all that is required.

The set contains:

2x 1M guide with holes

2x  drilling colet

1x 3mm drill bit

1x 20mm drill bit with 3mm tip

3x pin for guides

1x guide with drill bushings

2x low Dog support for ponk 20mm

1x suction attachment

The UJK Parf Mk II system is the result of a collaboration between Axminster Tools and Mr. Peter Parfitt. The system is manufactured entirely in Axminster, Devon under the UJK brand.

UJK Chamfer Ring© is the intellectual property of Axminster Tools Ltd. Any violation is strictly prohibited.